5. Sodium Bicarbonate Injection
Effects of Sodium Bicarbonate Injection
Sodium Bicarbonate Injection may also be indicated in severe diarrhea which is often accompanied by a significant loss of bicarbonate. [1]
Sodium Bicarbonate Injection, USP is a sterile, nonpyrogenic, hypertonic solution of sodium bicarbonate (NaHCO) in water for injection for administration by the intravenous route as an electrolyte replenisher and systemic alkalizer. Solutions are offered in concentrations of 7.5% and 8.4%. [2]
graphic Additives
Additionally, a secondary system would be installed for the capture of carbon dioxide. The resulting byproducts are an ammonium sulfate (AS) fertilizer wet cake and a carbon dioxide stream. [4]
Additives may be incompatible. Consult with pharmacist, if available. [5]
graphic Drug
Drug induced fever can occur. Neurotoxicity has been observed in animal studies but not in humans. [8]
Drugs.com does not assume any responsibility for any aspect of healthcare administered with the aid of information provided. The information contained herein is not intended to cover all possible uses, directions, precautions, warnings, drug interactions, allergic reactions, or adverse effects. [9]
graphic Different Solutions
Solutions in contact with the plastic container may leach out certain chemical components from the plastic in very small amounts; however, biological testing was supportive of the safety of the plastic container materials. Exposure to temperatures above 25?C/77?F during transport and storage will lead to minor losses in moisture content. [10]
Solutions up to 4,2% (0,5 mmol/ per mL) of sodium bicarbonate are administrated intravenously for the rapid correction of acidosis. Solutions containing up to 8,4% (1 mmol per mL) are used for the initial treatment of metabolic acidosis caused by cardiac arrest. [11]
Solutions inside the plastic container also can leach out certain of its chemical components in very small amounts before the expiration period is attained. However, the safety of the plastic has been confirmed by tests in animals according to USP biological standards for plastic containers. [12]
graphicSO2
SO2 removal efficiency increased with gas residence time, water flow rate, inlet SO2 concentration, and applied corona power. Corona discharge forced the charged SO2 to reach equilibrium with the water. [17]
SO2 concentrations were measured upstream of the reagent injection, 25- ft (7.62 m) downstream of the injection point, and downstream of the electrostatic precipitator. [18]